cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
1830
Views
5
Helpful
1
Replies
anitachoi3
Beginner

loopback address for 2960

Hi,

For the router devices, it is suggested to configure the "loopback interface" for keeping router working stable.

For the L2 switch, is it the best practice to configure the loopback address for achieving the same purpose?

rdgs

1 ACCEPTED SOLUTION

Accepted Solutions
paolo bevilacqua
Hall of Fame Master

Not really. Put the address in the management VLAN is enough. If the management VLAN goes down, you have a bigger problem than just telnet to the switch.

View solution in original post

1 REPLY 1
paolo bevilacqua
Hall of Fame Master

Not really. Put the address in the management VLAN is enough. If the management VLAN goes down, you have a bigger problem than just telnet to the switch.

View solution in original post