cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
182
Views
5
Helpful
2
Replies
Beginner

Migrating Network Clock Commands from C2900 series to a ISR4351

I am having an issue migrating the following commands from a 2900 to an ISR4351. I'm not that familiar with the clocking commands. Can someone provide an example of what I need to use on the ISR?

Routing, ISR 4000 Series

network-clock-participate wic 1

network-clock-select 1 T1 0/1/0

 

Not sure what to replace the wic 1 

network-clock participate ??

 

When I try to apply the following I get the G.781 message....

network-clock select 1 controller T1 0/1/0
G.781 based clock selection process is enabled Please unconfigure G.781 based configuration before configuring network-clock select config command

 

Best Regards,

2 REPLIES 2
Advocate

Re: Migrating Network Clock Commands from C2900 series to a ISR4351

Highlighted
Rising star

Re: Migrating Network Clock Commands from C2900 series to a ISR4351

check if command below is present in your configuration

 

network-clock synchronization automatic

Enables the network clock selection algorithm. (Note that network clock synchronization is disabled by default.) Disables the Cisco-specific network clock process, and turns on the G.781-based automatic clock selection process.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards