12-04-2017 03:17 AM - edited 03-05-2019 09:35 AM
Sir,
I have 2 ISP connection in my Infra and primary is MPLS who working on BGP protocol and secondry is Point 2 point who is working on Static route. I need to do a fail-over between BGP to static vice versa
Thanks regard
Mohsin Hiroli
Solved! Go to Solution.
12-04-2017 03:20 AM - edited 12-04-2017 03:23 AM
Hi
You could use IP SLA + tracking + EEM Scripting, or you could configure the static route with higher administrative distance than received by the MPLS.
12-04-2017 03:20 AM - edited 12-04-2017 03:23 AM
Hi
You could use IP SLA + tracking + EEM Scripting, or you could configure the static route with higher administrative distance than received by the MPLS.
12-20-2017 03:13 AM - edited 12-20-2017 03:14 AM
Sir,
when i configure the static route with higher administrative distance it will take 60 sec delay to switch the line is the another way to decrease the down time.
12-20-2017 04:39 AM
Hi
Try to include this command line under the BGP peering:
neighbor ip-address fall-over
https://www.cisco.com/c/en/us/td/docs/ios/12_0s/feature/guide/cs_bsfda.html
12-04-2017 03:23 AM
Dear Mohsin,
Please consider that the type of connection is not important in this scenario and what you should consider is routing. Since BGP has two administrative distances (20 for eBGP and 200 for iBGP), according to your destination that you have a route for, you can assign an administrative distance to your static route, as bellow:
Static route with ADHTH,
Mahdi
12-20-2017 03:11 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide