06-12-2023 06:14 AM
Hey, I am a student and new to Cisco packet tracer.
I am trying to enable DHCP on my router 3 for my LAN network.
I have 3 VLANs in my LAN network: VLAN 30, VLAN 40, and VLAN 50.
They all have to ping each other and the web server 64.100.100.10, the TFTP server, and the IT pc.
Here is the network file.
Thanks in advance.
Student HoGent
Solved! Go to Solution.
06-12-2023 06:34 AM
Hi
You did everything right. The only thing I found missing was put the interfacce between the switch S4 and Router R3 in trunk mode.
06-12-2023 06:21 AM - last edited on 06-20-2023 02:49 AM by Translator
ip dhcp pool MHM-30
network <VLAN-30>
default-router <VLAN-30 subinteface IP>
dns-server <VLAN-30 subinteface IP>
same for all other VLAN 40 & 50
Sorry I dont install packet tracer' I answer to your post title.
MHM
06-12-2023 06:34 AM
06-12-2023 06:43 AM
Hey @Flavio Miranda
Thx, I was searching for this for a couple of hours now, not finding what the problem was.
Thanks a lot.
06-12-2023 06:50 AM
You did everyhing right, congrats. This interface thing was only distraction.
06-12-2023 07:49 AM
Hey @Flavio Miranda,
What was the missing command, between S4 and R3.
So I can do it on my own next time.
06-12-2023 08:01 AM
On the interface between S4 and R3 you just neet to run on the switch side
switchport mode trunk
06-12-2023 08:12 AM
But between S4 and R3 there is another switch S2?
06-12-2023 08:24 AM
On the interface with the arrow, you config as trunk mode
06-12-2023 08:26 AM
Okay thx, so it was on S2 and R3
06-30-2023 09:26 AM
Hi, thanks! I was looking for this solution. I created DHCP pools for each VLAN by specifying an IP address range, subnet mask, default gateway, and DNS server, but I got an error.
06-30-2023 09:34 AM
Hi
Create a new post, attach you project and I can help you. Just let me know
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide