N9372 config NTP not succeed

[zwgff]

HI, everybody, I set on a cisco N9372 switch config NTP, show that why not to take effect.

NXOS image file is: bootflash:///n9000-dk9.7.0.3.I1.1a.bin

config:

Feature ntp

clock timezone CST 8

ntp server 10.104.240.21 prefer
ntp server 10.104.240.22
ntp source-interface  loopback0

----------------------------------------------------------------------------

show that why not to take effect

show ntp status:
Distribution : Disabled
Last operational state: No session

The configuration have what problem, what else need to modify, thank you for your attention!

[Martin Hruby]

Hello

Can you please post the output of show ntp peer-status ?

Best regards,
Martin

[zwgff]

hello 

CS9372A# show ntp peer-status 
Total peers : 2
* - selected for sync, + -  peer mode(active), 
- - peer mode(passive), = - polled in client mode 
    remote               local                 st   poll   reach delay   vrf
-------------------------------------------------------------------------------
*10.104.240.21          10.104.240.3            8   64     377   0.00066 default
=10.104.240.22          10.104.240.3           16   64       0   0.00000 default

Best regards,

[Martin Hruby]

Hello

Your configuration is correct, the device is synchronizing with 10.104.240.21 as indicated by the output of show ntp peer-status.

On some NX-OS versions you can also verify this using show clock where NTP is reported as the time source.

Best regards,
Martin

[zwgff]

Hello, thank you very much