Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Labels

Forum Posts

Start a conversation

Resolved! ACL Help

Hello, I have the following subnet 10.73.23.0/24 printers are in the 20-100 range for IP's and I want to create an ACL to lock down SNMP from a few managers only to those printers. Is there a way to do this without putting in 80 lines of ACL's usin...

dcanady55 by • Level 3
  • 3857 Views
  • 18 replies
  • 0 Helpful votes

Resolved! Remote Office 3850 tunel to HQ options?

Hello we have a 3850 at each of our remote sites and I would like to configure ISP failover (IP SLA?). The 3850 Primary ISP is connected through a MPLS metro LAN service back to HQ. The Secondary ISP is going to be connected through a Cellular LTE br...

YanL by • Level 1
  • 1404 Views
  • 3 replies
  • 0 Helpful votes

Regular Expressions Show Command Help

I am practicing my show commands using regular expressions and need some help. I have the below expression working, but want to filter it further so it only shows the total out drops with the corresponding interface. Similar to interface G1/0/7. Can ...

bret by • Level 3
  • 1263 Views
  • 2 replies
  • 0 Helpful votes

Resolved! IP Dhcp snooping and IP Source Guard

Good day to all How to enable dhcp snooping and ip source guard, so that the user of the VLAN 60 (PC1) was not able to use other static addresses except 192.168.20.2 from DHCP, while not affecting the other VLAN? The scheme does not change and there ...

Resolved! SUP720-3B <-- Diagnostic logs, how can people make a decision certain results?

 Hello all, I have WS-X6704-10GE-3BXL. But, it suddenly failed. So, I verified by typing command : diagnostic start module 3 test (Please see the attached text file.) I examined the file, but I didn't realize what the reason for resetting. 6704-10G...

show call active voice summary

cisco 2921 router, has two voice PRI lines connected to it from AT&T, and then PRI tie lines to our internal PBX. when I do a "show call active voice summary", the "telephony call-legs" number includes open channels on the carrier PRI side and on the...

Resolved! Cisco 4431 router

Hello everyone, We have a Cisco 4431 router and need your help with the SFP modules - for some reason all four remain down know matter how we configure them, if we plug a copper CAT5 e cable into the port marked GI0/0/0 that interface comes online. W...

About ospf Netwoks types?

What is the difference between broadcast multi access point and non broad cast multi access point ?  is there any DR and BDR process in Non broadcast multi access point network?

Resolved! Need help with OSPF lab

Hello, I was wondering if you could help me : I was doing the lab 3-2 on this pdf : http://www.kis.fri.uniza.sk/~palo/Netacad/LST/ccnp-route-v6/en_ROUTE_SLM_v6000.pdf I used this configuration the the three routers : Router R1hostname R1!interface ...

Load more