nat static for a range of port

[harinirina]

Hi,

We need to do a nat static, in a router, for a range of port.

Is there a simpler way than entering many "ip nat inside source static udp 192.168.x.x" to do that ?

[a-vazquez]

Static addresses should not be members of the global address pool.If the internal host requires Internet access, the static address should be a NIC-registered address.Refer the following URL for more information regarding this

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a00800eb730.html