cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1505
Views
0
Helpful
2
Replies

NBN Connection requires PPPoE with 802.1Q VLan tagging

DON BROWN
Level 1
Level 1

We have a new NBN Internet that was supplied with an Audiocodes MP264.

The WAN connection uses PPPoE over Vlan 100

The ISP advises this router does not support bridge mode so they have provide a TP-Link TD-VG5612 that does.

I have a Cisco C881-K9 that was used with my previous ISP that I want to use with this new connection.

I am looking for a simple example how I can establish the WAN connection with this router.

The part I am stuck on is how to tag the WAN connection with Vlan 100.

Any assistance appreciated.

Thanks

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

Router configs for NBN, go HERE.

Thank you for that prompt reply.

I had seen the post on whirlpool but from what I can see that does not provide the vlan tagging on the wan connection ?

Or am I missing something ?

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card