cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
545
Views
0
Helpful
3
Replies

Need to know if it is possible to run OSPP between two Switches running VRRP

mahesh18
Level 6
Level 6

Hi Everyone,

 

We have below setup where Switches 1 and 3 are running VRRP between them.

They are not cisco switches.

 

Both the switches have OSPF nei to the core routers.

Problem is that if core Router 1 is down then some users can not access the Internet as Sw1 has no route for inside users.

IS there any way if i can create the OSPF nei between Sw1 and 3 so that if Sw1 lose the connection to Core Router 1 it can have ospf routes learned from the Sw3?

 

Best Regards

MAhesh

1 Accepted Solution

Accepted Solutions

Philip D'Ath
VIP Alumni
VIP Alumni

It is hard to speak for another vendor - but if it was Cisco switches you could.

View solution in original post

3 Replies 3

Philip D'Ath
VIP Alumni
VIP Alumni

It is hard to speak for another vendor - but if it was Cisco switches you could.

Currently switch 1 and 3 both are advertising the ospf routes to the core devices.

IF i run the point to point OSPF  between the two switches with lower cost then they will learn the below routes from ospf

 

routes from core router

will they learn static routes in new ospf neiship which they advertise to ospf?

yes i was able to do that.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card