Route traffic from inbound switchport toward outbound L3 interface

[USD SmartAlerts]

I am wondering if this is possible. I was trying with policy based routing, but I think I was barking up the wrong tree. We have a 3925 router. For a specific subnet, all traffic comes in to g0/1/1 (switchport). I need to force it to exit G0/2 (L3 interface). As I said, I tried PBR, but the 'ip policy' command is not available on g0/1/1. Very green admin here. Any ideas? Thanks!

[joseph.h.nguyen · Accepted solution]

It is as expected.  PBR is a feature for layer 3 interface.  Instead applying your PBR on g0/1/1, you can apply it to your SVI interface.