I am trying to configure Netflow support on a new 4451 and cannot get the following commands to accept. Can someone advise me please.
Cisco IOS XE Software, Version 03.10.00.S - Extended Support Release
Cisco IOS Software, ISR4400 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.3(3)S, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Thu 25-Jul-13 17:45 by mcpre
Technology Package License Information:
-----------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------
appx None None None
uc None None None
security None None None
ipbase ipbasek9 Permanent ipbasek9
(config-if)#ip route
(config-if)#ip route-c
(config-if)#ip route-cache ?
cef Enable Cisco Express Forwarding
policy Enable fast-switching policy cache for outgoing packets
same-interface Enable fast-switching on the same interface
<cr>
Only command available
(config-if)#ip flo
(config-if)#ip flow ?
monitor Apply a Flow Monitor
