hi,
i've applied this netflow config in our NCS 540 IOS-XR router which is an MPLS P router.
i checked in our netflow analyzer there's only 2-way/point-to-point traffic/OSPF between this router and another P router also an NCS 540 via the G0/0/0/19 link.
is there an additional command missing to "drill down" the MPLS traffic to see other top talker/IP address?
is sFlow should be configured instead?
flow exporter-map EXPORTER
destination 10.1.1.10
transport udp 2055
source Loopback0
version v9
template data timeout 60
template options timeout 60
options interface-table
options sampler-table
sampler-map SAMPLER
random 1 out-of 500
flow monitor-map MONITOR
record ipv4
exporter EXPORTER
cache entries 1000000
cache timeout active 60
cache timeout inactive 30
cache timeout rate-limit 2000
interface GigabitEthernet0/0/0/19
flow ipv4 monitor MONITOR sampler SAMPLER ingress