cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1887
Views
0
Helpful
18
Replies

New 4331 very slow and intermittent internet

Jkad432
Beginner
Beginner

Hello all,

 

 replaced a 2900 router with a new 4331 isr. Worked great for 5 days and then Became increasingly unresponsive. Reset to factory and started from scratch again and it works (local network works great) seeing some packet loss pinging external ip from an external network and it’s very slow loading web pages, I currently have the trial boost license. I have gotten the notice that I was approaching the license cap one time. Negotiation is set to auto.

 

any ideas what would be causing such slow speeds

18 Replies 18

Jkad432
Beginner
Beginner

sh license

Index 1 Feature: appxk9                         

        Period left: Not Activated

        Period Used: 0  minute  0  second 

        License Type: EvalRightToUse

        License State: Active, Not in Use, EULA not accepted

        License Count: Non-Counted

        License Priority: None

Index 2 Feature: uck9                           

        Period left: Not Activated

        Period Used: 0  minute  0  second 

        License Type: EvalRightToUse

        License State: Active, Not in Use, EULA not accepted

        License Count: Non-Counted

        License Priority: None

Index 3 Feature: securityk9                     

        Period left: Not Activated

        Period Used: 0  minute  0  second 

        License Type: EvalRightToUse

        License State: Active, Not in Use, EULA not accepted

        License Count: Non-Counted

        License Priority: None

Index 4 Feature: ipbasek9                       

        Period left: Life time

        License Type: Permanent

        License State: Active, In Use

        License Count: Non-Counted

        License Priority: Medium

Index 5 Feature: FoundationSuiteK9              

        Period left: Not Activated

        Period Used: 0  minute  0  second 

        License Type: EvalRightToUse

        License State: Active, Not in Use, EULA not accepted

        License Count: Non-Counted

        License Priority: None

Index 6 Feature: AdvUCSuiteK9                   

        Period left: Not Activated

        Period Used: 0  minute  0  second 

        License Type: EvalRightToUse

        License State: Active, Not in Use, EULA not accepted

        License Count: Non-Counted

        License Priority: None

Index 7 Feature: cme-srst                       

        Period left: Not Activated

        Period Used: 0  minute  0  second 

        License Type: EvalRightToUse

        License State: Active, Not in Use, EULA not accepted

        License Count: 0/0  (In-use/Violation)

        License Priority: None

Index 8 Feature: hseck9                         

Index 9 Feature: throughput                     

        Period left: 7  weeks 4  days

        Period Used: 6  days 19 hours

        License Type: EvalRightToUse

        License State: Active, In Use

        License Count: Non-Counted

        License Priority: Low

Index 10 Feature: internal_service           

Jkad432
Beginner
Beginner

should i upgrade the ios xe software?

Jkad432
Beginner
Beginner

Here is my LAN sh inter

GigabitEthernet0/0/1 is up, line protocol is up

  Hardware is ISR4331-3x1GE, address is 3c13.cccc.c351 (bia 3c13.cccc.c351)

  Internet address is X.X.X.X/23

  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,

     reliability 255/255, txload 2/255, rxload 65/255

  Encapsulation ARPA, loopback not set

  Keepalive not supported

  Full Duplex, 1000Mbps, link type is auto, media type is RJ45

  output flow-control is off, input flow-control is off

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:00, output 00:00:00, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 57305

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 257319000 bits/sec, 31292 packets/sec

  5 minute output rate 8508000 bits/sec, 11136 packets/sec

     1849991537 packets input, 1883417327760 bytes, 0 no buffer

     Received 80916 broadcasts (0 IP multicasts)

     40802 runts, 0 giants, 0 throttles

     646549 input errors, 646549 CRC, 0 frame, 0 overrun, 0 ignored

     0 watchdog, 73977 multicast, 0 pause input

     648020027 packets output, 101963949439 bytes, 0 underruns

     0 output errors, 0 collisions, 5 interface resets

     1620 unknown protocol drops

     0 babbles, 0 late collision, 0 deferred

     5 lost carrier, 0 no carrier, 0 pause output

     0 output buffer failures, 0 output buffers swapped out

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend
 Full Duplex, 1000Mbps, link type is auto, media type is RJ45
     646549 input errors, 646549 CRC, 0 frame, 0 overrun, 0 ignored

Potential speed/duplex mismatch error.

This is a copper port.  The port configuration should be auto speed/auto duplex.  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers