Hello everyone,
a bit strange but pppoe doesn't work after change to 15.1.4M9 on 877:
"DDR: No free dialer - starting fast idle timer."
This is the important part of what was working config:
!
interface FastEthernet3
switchport access vlan 10
no ip address
!
interface Vlan10
no ip address
pppoe-client dial-pool-number 1
!
interface Dialer1
ip address negotiated
ip access-group EAL_WAN_IN in
ip access-group EAL_WAN_OUT out
ip nat outside
ip inspect FIREWALL out
ip virtual-reassembly in
encapsulation ppp
dialer pool 1
dialer string 8134
dialer-group 1
ipv6 address autoconfig default
ipv6 enable
ipv6 verify unicast reverse-path
ipv6 dhcp client pd NODE-PD rapid-commit
ipv6 inspect FIREWALL out
ipv6 traffic-filter WAN_IN in
ipv6 traffic-filter WAN_OUT out
ppp authentication chap callin
ppp chap hostname ********@*******
ppp chap password 7 **************
no cdp enable
!
The first problem was "DDR: Cannot place call, no dialer string set."
After adding dialer string to Dialer1, now "DDR: No free dialer - starting fast idle timer." regardless if I leave the pppoe-client dial-pool-number 1 in Vlan10 or FastEthernet3.
Any suggestions?
Thank you
-Dan