Hi All
Why am I recieving packets input, but last input shows 1w2d ?
GigabitEthernet2/0/15 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0018.73e3.a10f (bia 0018.73e3.a10f)
Description: link to btw
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 50/255, rxload 70/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 1w2d, output 00:00:22, output hang never
Last clearing of "show interface" counters 00:12:08
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2767000 bits/sec, 575 packets/sec
5 minute output rate 1968000 bits/sec, 540 packets/sec
418843 packets input, 258013452 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
393728 packets output, 186379642 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
