Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Resolved! login prompt

Hello,If I have my con, aux and vty lines configured with password and "login" before, once I add tacacs to the router, the word "login" disappeared from the config under the con,aux and vty lines. From the command lookup tool, it says login cannot ...

Hi,I have two routers running HSRP between them. In active router a wireless link is comming over ethernet and one serial link is comming on second router.when its router redudancy it works fine but i want that when my wireless link fails the traffi...

Resolved! Reg: Prefix List

Hi Guys,What does the following prefix-list mean. Does it mean permit a default route to the neighbour (i mean send a default to the neighbour) ip prefix-list BGP-to-Telstra seq 10 permit 0.0.0.0/0And also what does the following mean. specially the ...

Hi,When we assign a b/w in policy map with priorty commad(LLQ)to voice , let say 10M on 34M link, can this b/W will be available to data when no voice call active?Regards.

Hi all,I can't traceroute across a SVTI tunnel. I can ping across the SVTI using local subnet router interface as ping source and this works fine. Normal WAN traffic seems to be unaffected.Do SVTIs support traceroute? I have setup a SVTI tunnel betwe...

HiI'm very new and have my first Cisco router deployed in a SOHO setting with 4 pcs and an ADSL link over ATM for internet connectivity.I have the router running from reset to default but it is exposed. It returns a ping and I would like to stop that...

bobwallum by Level 1
  • 410 Views
  • 2 replies
  • 0 Helpful votes

We have access to a privately owned fiber ring of a large corporation.We are providing a service to this corporation.Currently they have one single location connectiing to our MPLS cloud.We will be adding three new locations for them to access our se...

When accessing internet while bypassing the proxy it is very slow. I have check the ports on the switch and the internet facing firewall and there are no errors on them. In we connect via proxy it all works fine.Any suggestions on this.

hello. i've got a point to point OC-3 link between two cisco 7204s that i've implemented QoS over, but I need some verification that my configuration is doing what i intended it to.class-map match-all DMZ_in match anyclass-map match-all edge3000_out ...