08-07-2010 12:58 PM - edited 03-04-2019 09:21 AM
I'm setting up a stub area with 2 routers over a switch. I'm having a problem with getting the adjacency through the switch, but I get it if I use a crossover cable.
Besides the ports being active on the switch is there any other configuration that I need? i.e. a VLAN?
Thanks
Solved! Go to Solution.
08-07-2010 03:10 PM
Hello,
Please make sure that both ports where you have connected the routers are on
the same VLAN (same broadcast domain). Also, make sure that the switch
supports multicast traffic.
Hope this helps.
Regards,
NT
08-07-2010 03:10 PM
Hello,
Please make sure that both ports where you have connected the routers are on
the same VLAN (same broadcast domain). Also, make sure that the switch
supports multicast traffic.
Hope this helps.
Regards,
NT
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide