Hi,
Have a 1921 that has 3 eth connections (1 LAN, and 2 WAN) - I have 2 seperate OSPF processes (2 areas) on the WAN Ints - both upstream WAN's are sending defaults back to the 1921, and the 1921 is sending it's LAN range to them.
I have ip ospf cost 150 set on the "failover" WAN connection interface (Both on the 1921 and upstream), but the 1921 is preferring the default route from the "failover"?
The ospf processes are:
"failover" ospf 38 (And area 38)
"primary" ospf 40 (And area 40)
The default routes are both being received by the 1921, but it's preferring the "failover" Int with the ip ospf cost 150 configured?
Any suggestions as to why this is happening?
Thanks.
