07-28-2019 01:30 AM - edited 07-28-2019 01:33 AM
Can anyone help me to draw the diagram of this network? Just the six routers' position and the connection and I will be able to do the rest.
In Westeros, there are seven kingdoms as follows along with their population size and other characteristics of each kingdom:
2. The Mountain and The Vale – Population size 80
3. The Rock – Population size 1024
4. The Stormlands – Population size 250
5. The Reach
Castles under The Reach
Outside the wall:
Overall Specifications:
Solved! Go to Solution.
07-28-2019 09:47 AM
Hello,
attached the Packet Tracer project file.
1. The North router performs NAT using a pool of 2 IP addresses
2. Static routing is in place between the North and the Mountain router
3. Two routers with multiple Vlans attached use inter-Vlan routing, also known as router-on-a-stick
4. The backup route is using floating static default routes with an administrative distance of 121, which is higher than the administrative distance used by RIP (120)
07-28-2019 02:33 AM
Hello,
this is a massive project that will take you at least several hours to accomplish. Start out with putting one router in each kingdom, interconnect the routers and go from there. There is no indication in the project requirements as to what kingdom is supposed to be connected to what other kingdom, and what type of connection it is supposed to be.
What is your experience level ? A lot of stuff is involved here. In order to accomplish this, you need a lot more and a lot more detailed information.
07-28-2019 03:42 AM
07-28-2019 04:04 AM
Hello,
since there is no explicit requirement on how to interconnect the routers, you could indeed connect every other router to the North router. I am not sure what they mean with backup route for two cities, and whether it means a secondary route from the same router, or a completely different route through another router ?
07-28-2019 04:09 AM
yes secondary route for the same router. actually they asked to do floating
07-28-2019 05:17 AM
Hello,
I tell you what: I will put something together and send the Packet Tracer project file over. It will take a while, as stated, this is a fairly large project, involving quite a few things...
07-28-2019 09:47 AM
Hello,
attached the Packet Tracer project file.
1. The North router performs NAT using a pool of 2 IP addresses
2. Static routing is in place between the North and the Mountain router
3. Two routers with multiple Vlans attached use inter-Vlan routing, also known as router-on-a-stick
4. The backup route is using floating static default routes with an administrative distance of 121, which is higher than the administrative distance used by RIP (120)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide