10-04-2013 08:54 PM - edited 03-04-2019 09:14 PM
I am trying to find a good way to one-to-one NAT certain private addresses that are already permitted in a overload from the same pool used by PAT.
e.g.
access-list 5 permit 10.1.1.0 0.0.0.255
!
route-map Map-5
match ip address 5
!
ip nat pool pool-5 1.1.1.1 1.1.1.6 netmask 255.255.255.248
!
ip nat inside source route-map Map-5 pool pool-5 overload
!
ip nat inside source static 10.1.1.5 1.1.1.5
Would such a configuration work? Would that allow 10.1.1.5 to always use 1.1.1.5 but still do normal PAT for the other private and public addresses?
Solved! Go to Solution.
10-05-2013 12:35 AM
Hello
access-list 5 deny 10.1.1.5
access-list 5 permit 10.1.1.0 0.0.0.255
Res
Paul
Sent from Cisco Technical Support iPad App
10-05-2013 12:35 AM
Hello
access-list 5 deny 10.1.1.5
access-list 5 permit 10.1.1.0 0.0.0.255
Res
Paul
Sent from Cisco Technical Support iPad App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: