I have an 1841 as an edge router for a office of around 50 users. We are using a cloud SIP solution for voice only. We have been experieincing call quality issues and looking at the interface that is connected to our ISP I see pause output incrementing, could this be a cause for call quality to be an issue? The circuit is 100Mbs fiber handoff.
The counters were cleared 12 hours prior to this:
GigabitEthernet0/1/0 is up, line protocol is up
Hardware is PM-3387, address is 0025.846b.e132 (bia 0025.846b.e132)
Internet address is 22.214.171.124/30
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is autonegotiation, media type is ZX
output flow-control is XON, input flow-control is XON
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 17:58:41
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Hello, We are working on a spare switch (with 12 fibre modules), which needs to be used as the failover switch in our company data centre. Cisco switch model : WS-C3750-12S(PowerPC405) Can you confirm the below : i. Does this switch su...
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...