Re: POE ports - Page 2

eng_adel273 · ‎05-30-2018

I some of the POE ports are not working like port gi1/0/12 .

I tried to shutdown & no shutdown , but also not working. as in attached file

also Checked command "show power inline " and check the used/remaining power , it was 80/750

please help

eng_adel273 · ‎09-24-2018

I'm still facing the same problem , can you please advice

Leo Laohoo · ‎09-24-2018

Reboot the switch.

If the issue persist, post the complete output to the command "sh post".

eng_adel273 · ‎09-25-2018

I attached the required command

paul driver · ‎09-25-2018

Hello

most probably the switch poe is on it way out - it does happen

do the fauly ports work as normal access ports when POE is turned off?

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

eng_adel273 · ‎09-25-2018

Yes, the fauly ports work as normal access ports when POE is turned off

What can I do ?

paul driver · ‎09-25-2018

Hello

sounds like the Poe is faulty it does happen I would suggest you RMA it as Leo stated

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Leo Laohoo · ‎09-25-2018

@eng_adel273 wrote:
15.0(2a)EX5

Hold on. I am NOT troubleshooting anything that runs on "EX" image.

Upgrade to something more recent than a "re-build" like that.

eng_adel273 · ‎09-25-2018

can you please send a clear steps

Leo Laohoo · ‎09-25-2018

@eng_adel273 wrote:

can you please send a clear steps

Kindly read the Release Notes. There is a section which provides detailed steps about how to upgrade the IOS of a stack of switches.