12-09-2015 09:54 AM - edited 03-05-2019 02:54 AM
Hello fellow Cisco dudes:
Let me start my asking, have any of you, any of you at all had any trouble emulating PBR at your home labs? I cannot seem to make it work, and if you look at examples on the CCNP Route book, they say they use two Routers acting as hosts going through the "Policy Router" out to R2 and R4. I see the output of the Debug ip policy but I cannot ping router 2 or 4. Please help!!!!
12-09-2015 01:17 PM
Hello,
Please share you configuration. sketch of your topology would be helpful.
Masoud
12-10-2015 01:20 AM
Hi,
Do you have the return route available from the destination back to source?
I agree with Masoud here. If you are looking for any help, always provide detail information like, topology, configuration and supporting logs.
Just a problem statement is not sufficient.
HTH
-Amit
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide