Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After graceful shutdown of our standalone ISE 3.1 patch 8 instance, two services refused to come up: Application server and M&T Log Processor. Steps taken:1. Another graceful shutdown using the command "application stop ise" then rebooted the VM. Our...
Hi! I have a 3945 series router and if there is a power loss, or the router is rebooted, it loses controller, and WAN interface serial configuration. Any thoughts on what may be causing this? The confreg-register is at 0x2102 which is the correct set...
Real quick question, If I have a router, that is configured to utilize DHCP via ip helper address to distribute ip addresses from an external server, and I configure the router with a local dhcp configuration, will it revert to the local database and...
Need help, I have several 3560 48 port switches that hangs and locks when adding a new VLAN. I can reconnect via SSH but it hangs as well when issuing any command, including any SHOW commands. I run DENALI IOS version 16.3.6 on it. I believe it is a ...
Gotcha again. They further clarify, they will have different gateways since they it will be new address space. However the gateways for the new local DHCP server have not been configured yet so it will be pointing to a non-existent gateway. Bottom ...
Makes sense, yes it will have local and external, but the new local DHCP configuration will be for future ip address space and local usage of the new space vice an external dhcp server. It will be a completely different address space.
By the way the two sub-interfaces are on a different physical interface. For example, Gi0/0 ip address is 10.0.0.1/30 on R1 and the subinteraces is: Gi0/1 no shut, the Gi0/1.200, encapsulation dot1q, ip address 15.0.0.1/24. VLAN 200 is for the MGMT N...
I have tried that and I am having trouble still. It is a very simple topology on GNS3 and Packet tracer with two routers only, directly connected on a 10.0.0.0/30 interfaces, and two sub-interfaces with a 15.0.0.0/24 ip's. I have tried the "redistrib...
