Port Forwarding

[Translator]

Dear all good afternoon,

I need to port forwarding with NAT but not from a single port, but from a set of ports, specifically from port 10000 to 10250, this is possible.

Thank you very much.

Waiting for your comments.

[Translator]

Try the example below: if you mean a router :

https://community.cisco.com/t5/routing/forward-range-ports-for-few-hosts-in-isr4331/td-p/3316899

[Kasun Bandara]

what is the device model you are trying to configure?

[Translator]

Cisco 1841.

[paul driver]

Hello
Yes you can,
I assume you are using domain nat ( inside/outside)
Can you clarify if this is to be static or dynamic, using a single pubic ip address or specific public ip addressing?

Example:
ip access-list extended NATACL
permit tcp any any range 10000 10250
 
route-map STAN 
match ip address NATACL

ip nat inside source static 10.1.123.1  1.1.1.1 route-map STAN

[Translator]

greetings @fernandomoreno777523023 thanks for communicating with the Cisco community, the device you are referring to is a ASA, or a router ?

We'd like to know what device it is to be able to help you.