05-30-2018 04:25 AM - edited 03-05-2019 10:31 AM
Dear,
I have Cisco ISR 1111 router with 8 switch ports. I wanted to configure "switchport port-security" but I have no command. I use Fuji IOS XE 16.7. Is there any other similar command?
Thanks
Solved! Go to Solution.
05-30-2018 05:16 AM
since i've been looking right now for an very-small MPLS-capable-router, which the ISR1111 might be...
asking about port-security
* no hint to this feature in the IOS-XE-Configuration-Guides
* the Feature-Navigator (www.cisco.com/go/fn) => search by feature
...this tool is very often useful but sometimes it's database is not complete
=> shows no ISR-Router with "port-security" enabled (screenshot attached).
Zone-Based-Firewall might be an (maybe overengineered) solution!?
05-30-2018 05:16 AM
since i've been looking right now for an very-small MPLS-capable-router, which the ISR1111 might be...
asking about port-security
* no hint to this feature in the IOS-XE-Configuration-Guides
* the Feature-Navigator (www.cisco.com/go/fn) => search by feature
...this tool is very often useful but sometimes it's database is not complete
=> shows no ISR-Router with "port-security" enabled (screenshot attached).
Zone-Based-Firewall might be an (maybe overengineered) solution!?
05-30-2018 05:43 AM
It is strange because it has dot1x. Can I use mac access-list on switch port and control L2 access?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: