Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear,
I have Cisco ISR 1111 router with 8 switch ports. I wanted to configure "switchport port-security" but I have no command. I use Fuji IOS XE 16.7. Is there any other similar command?
Thanks
Hi,
I want to find what feature set I need to buy in order to have some feature but Cisco feature navigator doesn't help for ISR 4000. Example: If I find feature "IP SLA ICMP .." in CFN it says all feature sets support this feature. But I know that ...
Hi,
I need to encrypt trafic between two remote location 1Gb/s. I would like to use Cisco switches with MACsec.
1. Can I use WS-3560CX-12TC-S switches with sfp modules. I found that the switch support MACsec on downlink ports but I'm not sure about...
Hi, Can you send me your final design?I have two ASAs active/standby, two core switches in stack and one Fortigate in transparent mode on primary path. Secondary ASA is directly connected to switch.I want to add second Fortigate in backup path. Can I...
