Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(17), RELEASE SO
FTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Fri 07-Sep-07 14:45 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
Oki_1841 uptime is 11 minutes
System returned to ROM by power-on
System restarted at 20:46:13 JST Thu Mar 27 2008
System image file is "flash:c1841-ipbase-mz.124-17.bin"
Cisco 1841 (revision 7.0) with 114688K/16384K bytes of memory.
Processor board ID FTX1146Z0EV
2 FastEthernet interfaces
1 ATM interface
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
---------------
interface FastEthernet0/0
description Internal_Network
no ip address
ip nat inside
speed 100
full-duplex
bridge-group 1
interface FastEthernet0/1
description DMZ_Network
no ip address
ip nat inside
speed 100
full-duplex
bridge-group 1
interface ATM0/0/0
no ip address
no atm ilmi-keepalive
bundle-enable
dsl operating-mode auto
interface ATM0/0/0.1 point-to-point
no snmp trap link-status
pvc 0/32
pppoe-client dial-pool-number 1
interface Dialer1
description ADSL_WAN_Dialer
ip address negotiated
no ip redirects
no ip unreachables
no ip proxy-arp
ip mtu 1492
ip nbar protocol-discovery
ip nat outside
encapsulation ppp
ip tcp adjust-mss 1452
dialer pool 1
dialer-group 1
ppp authentication chap pap callin
ppp chap hostname xxx
ppp chap password 7 xxx
ppp pap sent-username xxx password 7 xxx
ppp ipcp route default
interface BVI1
ip address 192.168.1.1 255.255.255.0
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Dialer1
---------------
In the config here, I still have the BVI enabled - since I'm still trying to connect to my ISP via my Wic-1ADSL... But since I was having issues, I tried to just go through the ethernet port - to my isp provided modem...
And that's when I get the pppoe create subblock failed.
Even after I completely delete all the config under the Ethernet ports.
