I am having issues applying the service policy on a serial interface. I am getting the following error:
The present CIR value is 5. Configured Percent results in out of range kbps.Allowed range is 8-2000000.
The present CIR value is 5.
The bandwidth on the link is 128k and maximum bandwidth has been set to 100%. the policy map uses WFQ with WRED..
Please advise, the issue is not so well documented.
Please, paste the configutation here.
If you are configuring "bandwidth 5" under the policy/class config, it wont work. For percentage, you should use "bandwidth percent 5" instead.
I'm having the same issue with a link with 256K capacity.
priority percent 25
bandwidth percent 5
bandwidth percent 3
bandwidth percent 2
bandwidth percent 23
bandwidth percent 12
bandwidth percent 4
bandwidth percent 1
bandwidth percent 25
Configured Percent results in out of range kbps.Allowed range is 8-2000000.
The present CIR value is 7.
The following restrictions apply to the bandwidth command:
what I'm trying to understand is that I'm using the same policy in one interface with 128K and another with 512K and is working perfectly.
Problem is you are reserving too small bandwidth for some classes.
ciso IOS needs minimum of 8kb for a class
bandwidth percent 3 ---> 3/100*256 = 7.68 (which is less than 8k)
bandwidth percent 2 ---> 2/100*256 = 5.12 (which is less than 8k)
bandwidth percent 1 ---> 1/100*256 = 2.56 (which is less than 8k)
Please increase percentages to give above classes a minimum bandwidth of 8k
also reduce default class correspondingly to make total bandwidth not to exceed 100%