Good day!!
We have a router 7609 with Supervisor Engine 720 (WS-SUP720-3B) (Policy Feature Card 3 and MSFC3 Daughterboard) and We have to configure QoS over a FastEthernet interface on a WS-X6148-RJ-45.
When I try to apply the policy command I get the next log:
#service-policy output TEST_QOS
bandwidth percent command is not supported in output direction for this interface
Configuration failed on:
FastEthernet1/2
What kind of hardware and software requirements I need on my router to perfom QoS over ethernet interfaces??
Thanks for your help
Regards!!!
Rafael Turriago
