QoS starting point or QoS based on IP

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2012 11:37 PM - edited 03-04-2019 06:03 PM
Hello all,
My QoS experience and deployment is almost nothing. But I believe it will fix some poor voice quality we are having at some new sites. Can someone point me in the right direction? Here's a basic site deployment for us:
We are having some quality issues with voice coming in, sounds like a bad cell phone call, but outbound voice sounds good. Basically, can I set a QoS policy that prioritizes for traffic to and from the UC540 device's IP address on the Internet edge router? Our UC devices set in parallel with ASA's and other devices that need direct internet access. All sites use the UC devices only for Voice calls and use SIP trunks to different SIP providers.
Thanks for your time and support,
Nick
- Labels:
-
Routing Protocols
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-06-2012 09:43 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Typically, you can not apply fully effective QoS for your inbound traffic, and without being able to do so, while sharing Internet bandwidth with other applications, you can't properly support VoIP service requirements.
