Resetting a NIM-4MFT-T1/E1 to factory default

[Arron95]

Is there a process to reset NIM-4MFT-T1/E1 unit back to its factory default config? I know there probably isn't a simple command, but what I am looking for is a procedure to wipe the configuration as well as any stored data from the unit. The T1/E1 module is currently operating on a ISR4451 router

#NIM-4MFT-T1/E1

#ISR4451

#T1/E1

#Router

#NIM

[Georg Pauwen · Accepted solution]

Hello,

try:

default interface serial x
no card type {t1 | e1 } slot subslot

no controller {t1 | e1 } slot /subslot /port