RESOLVED - Cisco RV180 W vpn to vpn

[itgs_cisco]

Hello

I did a vpn to vpn between two RV180 W. I can establise a connection but after a while in the two device i get IPsec SA Not Established

Could someone help me with this problem ?

Thanks for the answer

Best regards

gic

[Roberto Kippins]

the isakmp session will time out if no traffic is going across the tunnel can you setup ip sla to send pings through the tunnel? this will keep it active.

[itgs_cisco]

thanks for your answer.

It's possible to do that in a cisco Rv180 W ?

[Roberto Kippins]

Hi I am not sure does it have a console port or a web interface I willl research the device

[itgs_cisco]

Thanks for your answer.

I found the solution. Go to Firewall - Attack Prevention and disable Stealth Mode. My vpn tunnels keep alive.