05-28-2013 02:27 AM - edited 03-04-2019 08:01 PM
Hello,
I have question regarding route reflector.
In my MPLS core network ,we have two route reflectors. Two route reflectors
and each PE routers are belonged to a peer group. Route reflectors are Cisco
7301. IOS 12.3. I have Hardware maintenace on one Routereflector. How can I
do that without interupting the end customer trafic.
Inside the mpls core network OSPF is used as IGP
PE<---->Route reflectors IBGP
Thank you
Manoj
06-03-2013 05:55 AM
Hello,
I assume that RRs are not placed in forwarding paths so no outage should happen if one of RR will go down.
Just to check:
- both RRs are advertising same prefixes?
- both RRs have same clients?
Best Regards
Please rate all helpful posts and close solved questions
06-03-2013 06:54 AM
Hello
Also are the RR clients logically AND physically connected to either RR because if they are just logically connected then when you reload one of the RR routers the RR clients attached to that RR router will be isolated?
res
Paul
Please don't forget to rate any posts that have been helpful.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: