Routing

Hi Guys,This is my first post and I hope it's posted in the right directory.I have a problem with Policy Based Routing on my router.It's a configuration which is working for a very long time.Recently I have add some additional rules to make use of th...

hi team, i am replacing the one of our customer Core router 7500 series to ASR 1006(IOS XE). in existing router ISDN link is terminated and no. of dialer interfaces created. please any one can help me out how to do the isdn configuration in ASR 1006....

                   i want to know is these configuration was right.My network was connected with Gi0/1 and Gi0/2 with Ip address of WAN and LAN IP respectively.WAN IP: 172.X.X.X and LAN IP:192.X.X.Xi am enabling EIGRP with  200commands in global conf...

        What are the possibilites that a router's snmp would just stop working?I have a 2811 router that was responding fine to my network management software. The router is NOT within my local network. So we had a nasty power outage where my monitor...

Hello,Is there a way to search for a MAC address of a device that I'm not sure is on the network? The user is not onsite so that person doesn't know what port the device is in. Thanks,Seannetta

For those of us who like to maximize 802.11n bandwidth with channel bonding, configuring the Dot11Radio interface in the integrated AP with "channel width 40-above" can essentially double bandwidth in areas with available WiFi channels. See page 9-13...

I noticed that different routers have different Maximum Burst Size (PCR) when configuring ATM vbr-nrt shaping see below,  which can be configured PCR only to 44209K. Another router has PCR of 40700K. Our contract speed( no CIR) with AT&T is 44736K (F...

Hi everyone, I wanted to start a discussion to get some of your thoughts and ideas in terms of what makes Dynamic Multipoint VPN, the technology of choice and some of the things that do not when it comes to an enterprise level deployment. I have a 7-...

Hi guys,Ive read about every example and issue regarding sending the copy commands yet still cannot seem to get the commands to work the switch was runnnig 12.2 so i upgraded it to 15 and yet the issue stays.Here is what the switch shows when I send ...

HI All,I have set a BGP routing Lab in GNS3  (topology and routers config attached)Everyting seems to be fine but whenever I shutdown the fa0/1 on Router R2 , R3 is not able to reach R2 networks (15,16,17 networks)Any help is highly appreciated.Thank...

Hello,What are your methods of proving an access list is working if you only have the router to test from remotely.We have a remote 3G router that I installed in another country that VPNs back to us and I don't have access to the devices on that LAN,...