09-27-2012 10:39 AM - edited 03-04-2019 05:41 PM
Hi
I tried to reset a pasword on a cisco adsl 37 router.
I followed the instructions posted in document: Document ID: 12065
"Password Recovery Procedure for the Cisco 806, 826, 827, 828, 831, 836, 837 and 881 Series Routers"
After step 9
(Type configure memory or copy startup-config running-config in order to copy the nonvolatile RAM (NVRAM) into memory)
I 'm stuck ; I get the following
Destination filename [running-config]?
dsl power-cutback 0
^
% Invalid input detected at '^' marker.
I have ios version 12.2(8).
Some advice?
Lieven H.
09-27-2012 12:55 PM
I am not sure I understand what happen?
When following the doc you got to the point where you changed the password and saving to start-up, is that correct?
I am assuming this is the doc you are following
Is this error after you hit enter?
09-27-2012 01:49 PM
That's correct.
copy startup-config running-config
I hit ENTER and then appears
Destination filename [running-config]?
I hit ENTER again and ten appears
dsl power-cutback 0
^
% Invalid input detected at '^' marker
thx for your reply.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: