Routing

Hello,From the remote VPN side (ASA 10.100.1.66) into the VLAN 10 network (10.104.10.x) on this routers LAN works inbound on ports in the 123 access list, however I need to allow VLAN 10 on this router to go outbound to the the remote ASA VPN (10.100...

I'm coming from a Cisco 837 with a static IP to a 2600 with a ADSL WIC. Same ISP, just moving to new equipmentI have debugging turned on, and get an IP and route from my ISP (AT&T) but when I try to use my static IP I do not get connectivity (and the...

Hi,I'm trying to build a project where I utilize a Cisco 877 as a dumb modem by briding the ATM interface together with an Ethernet interface (VLAN) in this case due L2 switchports.The online documentation for RFC 2684 bridging states that I should b...

Hi,Below you can see the tcp ip flow.The 192.168.23.2 is loopback address. The 10.15.x.x the external site which opens the XOT.Even though  there are keepalives between them, central router disconnects the connection.Anybody has any idei why does rou...

We have a WAN cloud, many of the connection subscribed as 10m, with 256k burst buffer. the traffic exceeds it. Verizon recommanded us to do shaping. but their words are so general. it said, "we recommed you configure 85-90% of the 10M, and leave the ...

Hi,    I would like to balance traffic on 2 route. For exemple, I have 2 router on site and to other site I have two other router. I create route between router 1 router to other router and an other route with 2 other router. So, in fact, I have two ...

Hi Experts,I'm trying to use BFD between PE and CE, but the session never comes UP. The configuration is pretty simple.Interface xxbfd interval 150 min_rx 150 multiplier 3router bgp xxxxneighbor x.x.x.x fall-over bfdFollow debug messages:Oct 26 12:11...

Ok, I have a little dilemma and am hoping to get some help from you super smart people out there.Here is my issue:I have a single ASR 1002 router that has 2 AVPN/MPLS DS3 connections coming in from our local telco.  We justrecently had the second one...

Hi,I am fairly new to Cisco, but am trying to configure a 1921 router to give higher priority to SIP/VoIP traffic (Port 5060) than everything else.The connection is only 4Mb and is getting hit hard by video streaming, I don't want to block this, just...