09-03-2013 03:53 PM - edited 03-04-2019 08:56 PM
Hi,
I have an Cisco 850 router (c850-advsecurityk9-mz.124-15.T17). The router is able to take the following command.
ip route 1.1.1.1 255.255.255.255 2.2.2.2 track 1
It shows up n the running-config
#show run | inc ip route 1.1.1.1
ip route 1.1.1.1 255.255.255.255 2.2.2.2 track 1
However, it doesn't show up in the routing table. If I remove the "track" keyword from the ip route command, then it works and shows up in the routing table. Although "ip sla" command and its sub-commands work, it seems "track" is not there in the global config mode or even in "show track".
Router(config)#ip sla 1 ?
<cr>
Router(config)#track ?
% Unrecognized command
Router(config)#rtr ?
% Unrecognized command
Is this expected ?
Regards,
Rick.
Solved! Go to Solution.
09-04-2013 05:08 AM
Hi,
From Cisco Navigator this feature is not available on the 850 platform.
Regards
Alain
Don't forget to rate helpful posts.
09-04-2013 05:08 AM
Hi,
From Cisco Navigator this feature is not available on the 850 platform.
Regards
Alain
Don't forget to rate helpful posts.
09-04-2013 05:14 AM
Thanks Cadet, had a look too and couldn't find it for the 850 series.
Regards,
Rick.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: