Routing between /27 and /30 block (VLAN to Physical WAN)
Sorry if this is a mega simple question, but we need to setup something like this:
The physical connectivity between the ISP network and External Switch 1 i.e. the /30 network is on port GigabitEthernet 0/19. The /27 network is configured as VLAN100. How do we configure such that all hosts in the 192.168.1.64/27 network can access the Internet using the .66 HSRP IP. Then of course we can configure routing in the Firewall to allow hosts in the internal network to access the internet too. But that's another story.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...