Routing

[ccrank]

Hello All,

I am new to networking and I'm sure that will be apparent by this question. In one of my classes we have been asked to put together this network(see attached). I have connected everything and assigned IP addresses. I have a server and two computers all using different gateways on the router.

I don't understand how I am supposed to make all of these reachable without a switch. Any hints?

PC1_TestNetwork
NIC1
192.168.1.101
255.255.255.0
192.168.1.100
PC2_TestNetwork
NIC1
192.168.2.101
255.255.255.0
192.168.2.100
Server_TestNetwork
NIC1
192.168.3.101
255.255.255.0
192.168.3.100
Router_TestNetwork
FastEthernet0/0
FastEthernet0/1
FastEthernet1/0
192.168.1.100
192.168.2.100
192.168.3.100
255.255.255.0
n/a

Thanks for any advice,

Chris

[balaji.bandi]

not sure what is the router image version using here.

can you post-show version and show run from the router.

try below tip 

no cef - old one has some bugs.

[ccrank]

 Sorry I have no choice except to use screenshots. I should try the same setup in packet tracer.

[ccrank]

The server has the correct ip address and gateway, but the two computers keep using 169(apipa)

I'm confused