Good morning. I have been using a Cisco RV110 at one of our remote branches to create a site to site VPN back to our head office. The site to site VPN is between the RV110 and our Watchguard XTM 535 firewall. This has worked very well but the branch office now needs to have an additional two site to site tunnels to different offices so I have bought the RV130 which supports up to 10 site to site VPNs. However when setting up just the first link between the branch and head office the tunnel is established and runs for a few hows but then drops and it seems impossible to reconnect without reconfiguring the whole site to site configuration. The phase 1 and phase 2 settings are exactly the same as they were on the RV110 and must be correct because the tunnel does come up for a few hours. The RV130 has the latest firmware installed. I need to roll a few of these RV130s out to other branches but can't do so until this issue is resolved. Assuming this is just a standard site to site link that I have created am I missing something in my configuration? Any help much appreciated. Thank you.
