cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
395
Views
0
Helpful
3
Replies

See if I can get a log file on Top Talker

ulrichkenneth1
Beginner
Beginner

Hi All,

 

This might be a long shot, but figure I post and see.

I have a VIP client that when they try to do certain things, it maxes out their 500Mb Internet connection.

I've enabled Top Talker on their Cisco ISR4331, and I know Top Talker is a real time application only.

Is there a way I can get the data to some kind of log file? like have the Cisco convert it to TopTalker.csv and tftp to pull it?

Or maybe use a program like PRTG or Solarwinds to reflect what Source/Destination IPs with the amount of bandwidth on each conversation?

1 Accepted Solution

Accepted Solutions

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

 

you could use an EEM applet such as the one below (which runs every 60 seconds):

 

event manager applet TOP_TALKER
event timer watchdog time 60
action 0.1 info type routername
action 1.0 cli command "enable"
action 2.0 cli command "show ip flow top-talkers"
action 3.0 file open fh flash0:top_talkers.csv w
action 4.0 file write fh "$_cli_result"
action 5.0 file close fh
action 6.0 cli command "copy flash0: tftp" pattern "Address"
action 7.0 cli command "w.x.y.z" pattern "filename"
action 8.0 cli command "$_info_routername-top_talkers_$_event_pub_sec"
action 9.0 syslog priority informational msg "Top Talker file written to TFTP server!"

View solution in original post

3 Replies 3

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

>Or maybe use a program like PRTG or Solarwinds to reflect what Source/Destination IPs with the amount of bandwidth on each conversation?

                                            -  That is probably the best option

 M.

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

 

you could use an EEM applet such as the one below (which runs every 60 seconds):

 

event manager applet TOP_TALKER
event timer watchdog time 60
action 0.1 info type routername
action 1.0 cli command "enable"
action 2.0 cli command "show ip flow top-talkers"
action 3.0 file open fh flash0:top_talkers.csv w
action 4.0 file write fh "$_cli_result"
action 5.0 file close fh
action 6.0 cli command "copy flash0: tftp" pattern "Address"
action 7.0 cli command "w.x.y.z" pattern "filename"
action 8.0 cli command "$_info_routername-top_talkers_$_event_pub_sec"
action 9.0 syslog priority informational msg "Top Talker file written to TFTP server!"

Thank you both for the information.

I'll try it out and see what happens!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: