setting up static IP for a printer using Cisco's ASA-5506?

[brandonivey99]

I was wondering if there's a way of setting up static IP for a printer using Cisco's ASA-5506?

[balaji.bandi]

I was wondering if there's a way of setting up static IP for a printer using Cisco's ASA-5506?

Question was not clear ?

can you explain more.

is the ASA Acting as DHCP ? if that is case you can do below :

dhcpd reserve-address 10.10.10.10 xxxx.xxxx.xxxx inside

[brandonivey99]

Hello, 

The goal is to setup a static IP for our printer, so it does not randomly changes ip. The ASA is acting as a DHCP server. 

[balaji.bandi]

The above example helps you to make static entry.

make sure when you make a static entry that is not in the pool, make sure you reserve the IP address.

dhcpd address 10.10.10.10-10.10.10.10.20 inside

 Once that is done, clear the arp table. and reboot the printer to get a static IP address.

[Georg Pauwen]

Hello,

which ASA software version are you running ? I think the DHCP reservation feature was added somewhere in release 9.1.3, so you need to have that installed...

[brandonivey99]

Hello,

Our ASA version is 9.14(3).18

[Georg Pauwen · Accepted solution]

Hello,

that version should be sufficient. Below is a sample config, does that work on your 5506 ?

dhcpd address 192.168.1.10-192.168.1.20 inside
dhcpd enable inside
dhcpd reserve-address 192.168.1.11 afe5.caef.356b inside

[brandonivey99]

gotten an ERROR: Binding exists for the IP. I'm assuming it's already setup? My end goal is to verify each branch location has a static IP for all printers. 

[Georg Pauwen · Accepted solution]

Hello,

if it is already setup, you should find the relevant configuration in the running config. If it is not there, the error message most likely means that a dynamic binding already exists. Before adding the static reservation, clear the existing binding using the

clear dhcpd binding x.x.x.x

command.