show arp not working
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-06-2024 10:53 AM
When I enter show arp, nothing is displayed.
- Labels:
-
Other Community Feedback
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-06-2024 11:47 AM
Try show ip arp
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-06-2024 11:52 AM
what router model - show ip arp should work.
or check the syntax depends on version (most case that should work)
show ?
show ip ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-06-2024 02:18 PM
Please post the output of show ip interface brief. We need to be sure that some interface(s) is/are up and assigned with appropriate IP addresses.
Rick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-06-2024 07:52 PM
as mentioned above, you must have interface in UP UP state (no shut interface with IP address assigned) to see local ARP in table.
Regards, ML
**Please Rate All Helpful Responses **
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-07-2024 02:16 AM
Hello dellarine07,
Make sure at least one interface is assigned with ip and up
Initiate some communication and check..!
Best regards
******* If This Helps, Please Rate *******
