SIP trunk in and out using 2951 with Vic3-FXS/DID card
I have an older non Cisco pbx that only accepts analog lines. We are planning to upgrade the phone services to SIP because the local carrier sucks and wont replace their lines to the location. While I have programmed the SIP trunks going to a newer pbx that does the registration to the SIP provider, I havent done anything with programming the FXS card or having the 2951 do all the registration of the trunks itself. Can anyone out there provide me a direction to go, other than upgrade the PBX (that is planned for late next year).
Cisco Digital Network Architecture Center Modules(Design Module)Part.2In this article, we are going to talk about the Cisco Digital Network Architecture Center design Module. Cisco DNA Center gives us the flexibility and availability to con...
Connectivity Design considerations and recommendation
1.Management Access connectivity
If there is a dedicated OOB management path, consider connecting to CIMC and MGMT port.
If OOB path is not available, Connect the dedicated Management port to LAN Swi...
Cisco Digital Network Architecture Center Modules In this article, we are going to talk about Cisco Digital Network Architecture Center design Module. Cisco DNA Center gives us the flexibility and scalability to configure multiple fabric sites a...
This document provides an overview of DPDK and steps to configure and troubleshoot DPDK for OVS in NFVIS.
DPDK stands for Data Plane Development Kit, is a set of libraries that improves data plane performance.DPDK description