09-23-2021 07:08 PM
I am doing a lab on Packet Tracer and I configured SSH on the router and after that, I am trying to access it through the PC command line. when I try to run SSH it gives me an error "Command invalid.". While you can see PC is pinging router using IP address 10.1.1.10.
Please help!!!
Thanks in advance
Solved! Go to Solution.
09-23-2021 08:34 PM - last edited on 03-06-2023 03:45 AM by Translator
Hi,
you should use below command. parameter should be -l (letter L in simple) not the number 1.
>ssh -l cisco 10.1.1.10
good luck
mark this as answer and upvote if this solved your concern
KB
09-23-2021 08:34 PM - last edited on 03-06-2023 03:45 AM by Translator
Hi,
you should use below command. parameter should be -l (letter L in simple) not the number 1.
>ssh -l cisco 10.1.1.10
good luck
mark this as answer and upvote if this solved your concern
KB
09-24-2021 12:28 AM
thank you soo much.
You solved my problem.
God Bless you
09-24-2021 12:02 AM
Hello,
what did you actually configure on the router ? Post the zipped Packet Tracer project (.pkt) file...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide