cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3803
Views
10
Helpful
3
Replies

Strange message at the end of booting Cisco1841

dvangyzeghem
Level 1
Level 1

Hello,

When we upgraded to IOS c1841-ipbasek9-mz.124-22-YB5 and reloaded the router we received following messages at the end of the boot process:

licensing flash block 0 needs to be initialized

licensing flash block 1 needs to be initialized

licensing flash block 0 needs to be initialized

licensing flash block 1 needs to be initialized

Does anyone know what this means.

Thank you in advance

Dimitri

1 Accepted Solution

Accepted Solutions

vragotha
Level 3
Level 3

Dimitri,

      This usually happens when unused parts of the Flash are being accessed. Try these steps

1. Reload the router again.

2. If the message appears again, format the flash and reload the IOS

View solution in original post

3 Replies 3

vragotha
Level 3
Level 3

Dimitri,

      This usually happens when unused parts of the Flash are being accessed. Try these steps

1. Reload the router again.

2. If the message appears again, format the flash and reload the IOS

hi Vijay,

Thank you for your reply.

When we reloaded the device the messages did not appear anymore.

So i presume this is just a notification message and cannot cause any problems?

Thanks again

Right, it should not cause any issues

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: