Routing

HiI'm quite new to telnet and I can't acces the Cisco firewall Pix501 through the web interface. I have a print from the PIX 501's settings and I can see that I have to change a users IP adress, since he has got a new IP adress.I hope that he can get...

Hello,I'm used to configure ASA with version 8.0. Since version 8.3 is installed on our ASA's port forwarding isn't function any more.Can someone help me with the configuration. Allready tried various options, but nothing works.Also can't see the tra...

Need you help people, I'm a bit rusty but need to get this done urgently. need to create a trunk from my office switch which will extend 2 existing vlans to and over WAN link. need to know how to setup and configure. it's really a test situation so i...

i want to configure some mitel handsets to use LLDP Med, i have a cisco 3750 configured with LLDP default and CDP turned off. I can plug a mitel phone into the port and the phone boots in the voice vlan, i presume this is because i have the (switchpo...

Dear All,I want some help in configuration.We are having 2 Branches (1 Head office & 1 is Branch Office). We are having MPLS Connection between 2 Offices. I am having Internet Connection @ my Head office. I want to connect two offices using MPLS Conn...

Hi,I am little bit confused with Bandwidth and Default-queue term in QOS. I have attached QOS below which is applied on 1 Mb link.I know, Data will get 600kb Minimum bandwidth and Max no guarentee. Default Queue has 10 %.What about if I have VOIP tra...

Hi All, I have a weird problem when in, I am unable to ping a router sub-interface IP address using a loopback or ethernet interface on the same router. Where as the same works on all other routers. Here is the configuration and ping status -interfac...

Hi all,We have the following :GigE ehternet circuit from ISP via fiber.Cisco 7206 (NPE-G2) RouterCisco 2960G Ethernet SwitchAll devices which process public traffic are also connected to ethernet switch.What would you recommend:Connecting ISP directl...

Does the ASA5500 series appliances do Dynamic DNS on the WAN interface to dyndns.org or tzo.com yet? IOS Routers do!Thanks,Jerry

folksi have a requirement to connect a small office, approx 6 users, in the US (washington) to the UK and i've been getting a few quotes for 2Mb leased lines and the results are scary, i.e. 25k (£) plusthe line needs to be encrypted so i'll be using ...

My cisco 2620 router always boots into rommon mode but after i reset it, it boots into the IOS. After i shutdown the router and power it up again it goes back to rommon mode ?I saved the running config to the startup config after setting up the regis...

I have a stack of 2 3750's.  I want to promote the member switch to become the master switch.  What is the command to do this?  Thanks!

I brought 2 cisco 2620 routers and only one worked properly the other displayed some unknown charecters in hyper terminal. Some friend of mine told me to try a bit rate other than 9600 so i did that and the router booted into rommon mode then he said...

HiI have a Cisco 1841 router connected to the ISP and I have the LAN side of the router connected to an ASA5510. The ASA5510 is in turn connected to a catalyst switch with 6 VLANs configured on it. The ASA5510 has subinterfaces which are connected to...