10-09-2019 12:23 PM
I am trying to setup sub interfaces on the LAN side of my router and am having issues getting out to the internet. Any suggestions? Here is my config
interface GigabitEthernet0/0
description To_WAN_Switch
no ip address
duplex auto
speed auto
!
interface GigabitEthernet0/0.1
description Guest_Network
encapsulation dot1Q 501
ip address 2.26.21.134 255.255.255.248
!
interface GigabitEthernet0/1
description InBound_From_Level3
ip address 2.9.15.118 255.255.255.252
ip access-group Block_Stuff in
duplex auto
speed auto
ip route 0.0.0.0 0.0.0.0 2.9.15.117
I've assigned the IP 2.26.21.129 on a laptop and can ping 2.26.21.134 but not 2.9.15.118 or outbound to the internet.
Solved! Go to Solution.
10-09-2019 12:45 PM
Hi @jkay18041
Check this out to start:
-Your Laptop has the correct gateway?
- Have you tried disabling the firewall of the Laptop?
-Do both networks exist in the routing table?
Regards
10-09-2019 12:45 PM
Hi @jkay18041
Check this out to start:
-Your Laptop has the correct gateway?
- Have you tried disabling the firewall of the Laptop?
-Do both networks exist in the routing table?
Regards
10-09-2019 01:55 PM
Helps when the fiber is plugged in :)
10-09-2019 02:07 PM
Why do you need sub interface if only 1 subinterface you configured on the device, instead you can directly configure the IP address to interface right?
10-09-2019 02:35 PM
Hello
The wan switch connection to the router need to be a trunk, The access port on the switch connection to your laptop needs to be in vlan 501, Lastly make sure the acl isnt negating access also?
10-09-2019 05:09 PM
I had forgotten to plug the fiber into the ISP switch after I removed it.
I only have 1 of the sub interfaces configured at the time.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: