Re: switch command (CLI) to show the ip address range

SebastienNjang9149 · ‎08-28-2020

I need the switch command (Nexus) to show the ip address range assigned to each vlan on the network. For example Staff_vlan 100 what are the valid ip address for this vlan?

balaji.bandi · ‎08-28-2020

You can view show run interface vlan x ( it will show you subnet mask assigned to that VLAN) - that is the range for VLAN (is that works for you )

you can also show ip arp all | in vlanX will give you what is active ? - if this nexus is Layer 3 for this vlan.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

pmckenzie · ‎08-31-2020

here is the cisco example

There are worlds out there where the sky is burning, where the sea's asleep and the rivers dream, people made of smoke and cities made of song. Somewhere there's danger, somewhere there's injustice and somewhere else the tea is getting cold" Dr Who